Desk Frame Assembly

 

Lay End Frame on Floor. Attach one of the 2 Rails (7/8" X 4" X 32 1/2" or 42 1/2" or 52 1/2"), onto a 3" screw at hole # 9 on the right rear leg ("RR") of the appropriate End Frame Assembly. Slot in Rails should face to inside of desk. Newer Desks have notches in their top surface. Make sure this notch faces up. Note: The 2 Rails may have several holes drilled for attachment of various options (Drawer Slides, etc.) Use 2 washers on the screw. Both washers should be under the head of their screw. Do not place a washer between the Rail and Leg. Wax the screw prior to insertion, and use the gauge block marked "leg to rail" to set height.

 

f you ordered a Desk with Hutch Shelf or a Sit or Stand Desk, you will get 1 or more additional Rails. These are installed between the rear Legs of the Desk after the Desk has been assembled and adjusted. This 3rd. Rail should be installed just under the first Hutch Shelf, or 2nd Monitor Shelf

 

 

Stand End Frame up

 

 Attach Rail to the other End Frame Assembly. Attach the second Rail in the front of the Desk.